BRAKES

More products by Other

Description

Hydraulics
  • Master Cylinder: When it comes to your vehicle, think of the master cylinder as a pressure converter. When you press down on the brake pedal (physical pressure), the master cylinder converts this to hydraulic pressure. This pressure is used to propel brake fluid to the wheel brakes.
  • Brake Lines and Hoses: Steel braided brake lines and high pressure, shock, and road resistant brake hoses are the channels which deliver pressurized brake fluid to the braking unit(s) at each wheel.
  • Wheel Cylinders and Calipers: Wheel cylinders consist of cylinders surrounded by two rubber-sealed pistons that connect the piston with the brake shoe. When brake pressure is applied, pistons are forced out, pushing the shoes into the drum. Calipers squeeze brake pads onto the rotor to stop your car. Both components apply pressure to friction materials.
Friction Materials
  • Disc Brake Pads and Drum Brake Shoes: A disc brake uses fluid (released by the master cylinder) to force pressure into a caliper, where it presses against a piston. The piston then squeezes two brake pads against the rotor, forcing it to stop. Brake shoes consist of a steel shoe with a steel shoe with friction material bonded to it.
How It Comes Together
  • When you first step on the brake pedal, you are triggering the release of brake fluid into the system of tubes and hoses, which travel to the braking unit at each wheel. This is because you actually push against a plunger in the master cylinder, causing the fluid to be released. Now because brake fluid can't be compressed, it journeys through the network of tubes and hoses in the exact same motion and pressure it initially began with. And when it comes to stopping a 2,000 pound steel assembly at high speed, this consistency is a good thing. But the performance of your brakes can be affected when air is introduced into the fluid; since air can compress, it creates sponginess in the pedal, which disrupts this consistency, and results in bad braking efficiency. The good news is that "bleeder screws" (located at each wheel cylinder) can be removed so that the brake system is "bled" to remove any unwanted air found in your system.

1 item added to your cart.


Quantity:  Update

Availability: Warehouse

Cart Summary

Item in Cart: 1

Subtotal: $0.00

Part Numbers

BRAKE-1
Delivery MethodRate*

* Listed shipping rates are calculated on this item alone, which may not apply if you have additional items in your cart. You may change your shipping preferences at any time by proceeding to your shopping cart.

Factory Promotions

Join us on Facebook!

Hours
Service Station Hours
Mon8:00 a.m.5:00 p.m.
Tue8:00 a.m.5:00 p.m.
Wed8:00 a.m.5:00 p.m.
Thur8:00 a.m.5:00 p.m.
Fri8:00 a.m.5:00 p.m.
Sat8:00 a.m.2:00 p.m.
SunClosed
Gas Station Hours
Mon5:30 a.m.9:00 p.m.
Tue5:30 a.m.9:00 p.m.
Wed5:30 a.m.9:00 p.m.
Thur5:30 a.m.9:00 p.m.
Fri5:30 a.m.9:00 p.m.
Sat7:00 a.m.9:00 p.m.
Sun8:00 a.m.8:00 p.m.

U-Haul rentals are available! Contact us at 908-788-7670.

Click here to schedule an appointment.